Skip to content
TrackPrep

Endothermic vs Exothermic Reaction: Difference, Examples and Graphs for NEET 2027 (NCERT)

Exothermic reactions release heat, so ΔH is negative; endothermic reactions absorb heat, so ΔH is positive. This NCERT-based guide adds enthalpy diagrams, real examples with values, why an endothermic reaction can still be spontaneous, the temperature effect on K and 5 MCQs.

By Anmol Sharma10 min read

Cartoon student comparing endothermic and exothermic reactions for NEET

In one line: An exothermic reaction releases heat to the surroundings, so its enthalpy change ΔH is negative and the products lie lower in energy than the reactants, while an endothermic reaction absorbs heat from the surroundings, so ΔH is positive and the products lie higher.

Get it on Google Play: practise free on the TrackPrep app

Endothermic vs exothermic reaction: key highlights

Particulars Exothermic reaction Endothermic reaction
Heat Released to the surroundings Absorbed from the surroundings
Sign of ΔrH (= qp) Negative Positive
Enthalpy diagram Products lie below reactants Products lie above reactants
NCERT example Combustion of butane, ΔcH° = −2658.0 kJ mol⁻¹ Decomposition of CaCO3, ΔrH° = +178.3 kJ mol⁻¹
Effect of raising temperature on K K decreases K increases
Where in current NCERT Class 11 Chemistry, Unit 5 Thermodynamics; Unit 6 Equilibrium (6.8) Same units

Table of contents

The one sign that decides everything

You met these words in Class 10 as "heat given out" and "heat taken in". For NEET you need the thermodynamics version, which rests on one NCERT line: ΔH = qp, the heat absorbed by the system at constant pressure.

From there the signs follow on their own:

  • In an exothermic reaction heat is evolved and the system loses heat to the surroundings. So qp is negative and ΔrH is negative.
  • In an endothermic reaction heat is absorbed, so qp is positive and ΔrH is positive.

Always read the sign from the system's side. If the reaction mixture gives away heat, its enthalpy falls, hence the minus, and the surroundings warm up. That is why an exothermic beaker feels hot and an endothermic one feels cold.

Reading the enthalpy diagram

NCERT Figure 5.10 shows both: for an exothermic reaction the products sit below the reactants, for an endothermic one they sit above, and the gap is ΔrH. Class 11 Biology (enzymes section) adds that either way the substrate must pass through a higher-energy transition state; that climb is the activation energy.

Difference between endothermic and exothermic reaction: full table

Basis Exothermic Endothermic
Heat flow System → surroundings Surroundings → system
ΔH (= qp at constant pressure) Negative (< 0) Positive (> 0)
Enthalpy of products vs reactants Products lower Products higher
Temperature of surroundings Rises Falls
Bonds (NCERT logic) Energy released in forming new bonds is more than energy used in breaking old ones Energy needed to break bonds is more than energy released in forming new ones
Need for heating Often none once started Often needs continuous heating (NCERT: "you have to heat" CaCO3)
K as temperature rises Decreases Increases
Strong case, by ΔrG° = −RT ln K Large negative ΔrH: K likely much larger than 1 Large positive ΔrH: K much smaller than 1
Typical NCERT examples Combustion, formation of water, NH3 synthesis, freezing Melting, vaporisation, CaCO3 decomposition, formation of NO2

📲 Practise these questions free in the app: solve this chapter's NEET PYQs, then quick Zap rounds. Open TrackPrep on Google Play

On the bond row: NCERT says energy is required to break a bond and released when one forms (H-H bond dissociation enthalpy is +435.0 kJ mol⁻¹). The balance decides the sign of the whole reaction.

Examples with NCERT values

Learn a few with their numbers. NEET likes to give you one value and ask for the reverse reaction or the sign.

Process ΔH (kJ mol⁻¹) Type
C4H10(g) + 13/2 O2(g) → 4CO2(g) + 5H2O(l) −2658.0 Exothermic
C6H12O6 combustion (also how the body gets energy from food) −2802.0 Exothermic
C2H5OH(l) + 3O2(g) → 2CO2(g) + 3H2O(l) −1367 Exothermic
H2(g) + ½O2(g) → H2O(l) −285.8 Exothermic
½N2(g) + 3/2H2(g) → NH3(g) −46.1 Exothermic
CaO(s) + CO2(g) → CaCO3(s) −178.3 Exothermic
CaCO3(s) → CaO(s) + CO2(g) +178.3 Endothermic
H2O(s) → H2O(l), fusion +6.00 Endothermic
H2O(l) → H2O(g), vaporisation +40.79 Endothermic
½N2(g) + O2(g) → NO2(g) +33.2 Endothermic
C(graphite) + 2S(l) → CS2(l) +128.5 Endothermic

Check the CaCO3 value the NCERT way: ΔrH° = [−635.1 + (−393.5)] − (−1206.9) = +178.3 kJ mol⁻¹. The forward and reverse reactions have the same size of ΔH with opposite signs. Melting is endothermic, so all enthalpies of fusion are positive; freezing gives the same heat back.

Is an exothermic reaction always spontaneous?

No. It feels natural to think "energy goes down, so the reaction must happen", like water flowing downhill. NCERT breaks that idea with two examples: forming NO2 (+33.2) and CS2 (+128.5) are endothermic, yet spontaneous.

The real test is Gibbs energy, ΔG = ΔH − TΔS:

ΔH ΔS Result
Negative (exothermic) Positive Spontaneous at all temperatures
Positive (endothermic) Positive Spontaneous when TΔS is large enough to outweigh ΔH, usually at high temperature
Negative (exothermic) Negative Spontaneous at low temperature
Positive (endothermic) Negative Not spontaneous at any temperature

Why are spontaneous exothermic reactions so common? The heat they release increases the disorder of the surroundings, so total entropy rises (NCERT, second law).

Temperature, equilibrium and solubility

This is where the topic crosses chapters.

Situation Exothermic case Endothermic case
Effect of higher T on K (Class 11, Equilibrium) K decreases K increases
Haber process, N2 + 3H2 ⇌ 2NH3, ΔH = −92.38 kJ mol⁻¹ Low temperature favours yield, but the rate is slow, so a catalyst is used Not applicable
N2O4 ⇌ NO2 experiment Formation of N2O4 is exothermic, so cooling lightens the brown colour High temperature favours NO2, brown colour deepens
Solids dissolving (Class 12, Solutions) If ΔsolH < 0, solubility falls as T rises If ΔsolH > 0, solubility rises with T
Gases dissolving in liquids Dissolution is exothermic, so gas solubility falls as T rises Not applicable

For most ionic compounds ΔsolH is positive, so most salts dissolve better on heating. For the reasoning behind these shifts, see Le Chatelier's principle with examples.

NEET traps to remember

  • Sign is for the system. "Heat released" means ΔH is negative, not positive.
  • Exothermic does not mean spontaneous. Check ΔG, not ΔH alone.
  • Exothermic does not mean no activation energy. Every reaction climbs to a transition state first.
  • Reverse the reaction, flip the sign. CaCO3 formation from CaO and CO2 is −178.3; its decomposition is +178.3.
  • Phase changes count. Melting and vaporisation are endothermic; freezing and condensation release heat.

Practice MCQs

1. For an exothermic reaction at constant pressure: (a) qp > 0 and ΔH > 0 (b) qp < 0 and ΔH < 0 (c) qp < 0 and ΔH > 0 (d) qp = 0

👉 Solve this and more Thermodynamics questions on TrackPrep

2. Given CaO(s) + CO2(g) → CaCO3(s); ΔrH° = −178.3 kJ mol⁻¹. The enthalpy change for the decomposition of 1 mol CaCO3(s) is: (a) −178.3 kJ (b) +178.3 kJ (c) −356.6 kJ (d) +89.15 kJ

👉 Solve this and more Thermodynamics questions on TrackPrep

3. Which of the following is an endothermic process? (a) Combustion of butane (b) Freezing of water (c) Vaporisation of water (d) Formation of NH3 from N2 and H2

👉 Solve this and more Thermodynamics questions on TrackPrep

4. An endothermic reaction with a positive entropy change will be spontaneous: (a) At all temperatures (b) At no temperature (c) When TΔS is greater than ΔH (d) Only at 0 K

👉 Solve this and more Thermodynamics questions on TrackPrep

5. For the exothermic reaction N2(g) + 3H2(g) ⇌ 2NH3(g), raising the temperature will: (a) Increase K (b) Decrease K (c) Not change K (d) Make ΔH positive

👉 Solve this and more Equilibrium questions on TrackPrep

Answer key

Q Answer Why
1 (b) Heat leaves the system, so qp and ΔrH are both negative
2 (b) Reverse reaction, same magnitude, opposite sign
3 (c) ΔvapH of water is +40.79 kJ mol⁻¹; the other three release heat
4 (c) ΔG = ΔH − TΔS turns negative only when TΔS outweighs ΔH
5 (b) NCERT: K of an exothermic reaction decreases as temperature increases

Practise on TrackPrep

  • ✅ Page-wise NCERT MCQs for Thermodynamics and Equilibrium, built from each NCERT page
  • ✅ Chapter-wise and year-wise PYQs plus custom tests to drill sign-of-ΔH and ΔG questions
  • ✅ Jojo, the AI teacher, sketches the enthalpy diagram on a whiteboard and walks you through it in Hindi, English or Hinglish; send a photo of any numerical. See what Ask Jojo is
  • ✅ Mistake Book and flashcards for the sign slips that cost easy Chemistry marks

Quick revision between classes? Try Zap, a free scroll feed with one question at a time. Comparing tools? Here is our best NEET practice app guide.

👉 Start practising free on TrackPrep

📲 Download the TrackPrep app for more practice: Get TrackPrep on Google Play

Related: Thermodynamics (Chemistry): NEET notes and questions · Equilibrium: NEET notes and questions · NEET Chemistry chapter-wise notes and questions

Practise for NEET on the TrackPrep app: get it on Google Play

Free in the app: every NEET PYQ of this chapter, chapter-wise and year-wise, with solutions.

Frequently asked questions

Is ΔH positive or negative for an exothermic reaction?

Negative. The system loses heat to the surroundings, so its enthalpy falls and ΔH is less than zero. For an endothermic reaction ΔH is positive.

Is an exothermic reaction always spontaneous?

No. Spontaneity depends on ΔG = ΔH − TΔS. An exothermic reaction with a large decrease in entropy can be non-spontaneous at high temperature, and NCERT gives endothermic reactions (forming NO2 and CS2) that are spontaneous.

What are some examples of endothermic reactions in NCERT?

Decomposition of calcium carbonate (+178.3 kJ mol⁻¹), formation of NO2 from N2 and O2 (+33.2), formation of CS2 (+128.5), and phase changes such as melting of ice (+6.00) and vaporisation of water (+40.79).

Is bond breaking endothermic or exothermic?

Bond breaking is endothermic, because energy is required to break a bond. Bond formation releases energy. A reaction is exothermic overall when the energy released in forming bonds is greater than the energy used in breaking them.

Last updated: 22 November 2026.

Tags:
  • chapter notes
  • difference between
  • neet 2027
  • chemistry

← All articles